GVAPO Tripinović – Founder, Nautical Armor Anodes
We deliver Operational Certainty.
A few weeks ago, one of our long-term European OEM customers told me that one of our larger shaft anodes needed a few light taps with a hammer to fit properly.
The allowed tolerance at one position was ±0.1 mm. We measured that position about 0.3 mm from the target dimension, which put us roughly 0.2 mm beyond the allowed limit.
It sounds tiny because it is.
A few light taps and the anode fitted. The installer lost only a few seconds.
The production tool was almost new. We had already invested heavily in developing it for this OEM model. Correcting that one position meant sending the tool back for redevelopment and spending thousands of euros again.
At the expected volume, the total investment in that model would take years to earn back.
That was the real dilemma.
We could keep an almost-new tool and accept a tiny adjustment during installation. Or we could spend thousands correcting one position so the anode fitted as intended from the start.
The customer could fix it in a few seconds. That did not make it their problem to fix.
Once we knew exactly where the dimension stood, I kept coming back to the installer at the boat.
They had bought an anode made for that application. Adding a hammer and an extra correction step to the installation moved part of our production work onto their side.
We explained everything to our customer: what we had measured, how small the difference was, what correcting it properly would require, and that we would bear the full tooling redevelopment cost ourselves.
They appreciated the honesty and our commitment to solve it properly.
A production mistake and the decision made after that mistake becomes visible are two different things.
Good tooling, inspections and experienced people reduce problems. They do not make real production perfect.
Once something is wrong and we know about it, another choice begins. Someone decides where the cost, time and inconvenience will land.
In this case, roughly 0.2 mm on our side meant extra work during installation on theirs.
Our partner already had an installation to complete. Adding the correction of our part to their job would have saved us thousands of euros and cost them only seconds.
We chose to keep that cost on our side.
Our partner had an installation to complete. We had a tool to correct.
So we corrected the tool.
GVAPO Tripinović | Founder | Nautical Armor